@Robert_Kyamoto wrote:
When upgrading from V2.5 to V3 should I have to update any parameters? I have a wild thumper, taranis, X8R SBUS, sabertooth, with a Pixhawk. I have the sabertooth in independent mode, with skid steer out on. After updating I only have control of the left bank of motors (fwd, reverse, left and right). If I swap the input channels on the pixhawk (1 to 3 and 3 to 1) I then have control of the right bank. I did not have this issue before updating. Any ideas?
Posts: 3
Participants: 2