@markoUA wrote:
Hello, I have been troubleshooting for several days with getting Guided mode to work for my rover.
Setup:
-Pixhawk with Ublox gps
-Spektrum DX6i tx with satellite reciever
-Sabertooth 2x60 speed controller (dip switch positions 1:Down, 2:Up, 3:Up, 4:Down, 5:Up, 6: Up)
-Skid steering setup with wheelchair motorsI am using left stick for throttle and right stick for steering. It works great in manual mode but flipping to Guided mode makes the rover spin in circles with only one motor operating.
There is GPS fix and the compass and GPS headings are pointing in the correct direction.
From the Pixhawk, I am using outputs 1 and 3 going into the Sabertooth S1 and S2 respectively.
I know people have had similar issues, but I have not found a solution that works. Any suggestions would be greatly appreciated as I am presenting the rover as my final engineering project in 2 weeks.
Thank you!
Posts: 1
Participants: 1